WAGNER Control Pro 150 User Manual

1
SPRAY
PRIME
2
AND
3
4
AND
5 6
PAGE 11
i
This procedure should be used when taking a short
term break or when ending your project for the day.
If your break is longer than 16 hours follow Cleanup
instructions, pages 17-18.
YOU WILL NEED
• Water
• Plastic bag
• Damp rags
• Stir stick
i
Instructions are for latex materials only! If using oil
based material follow instructions for Cleanup on
pages 17-18.
SHUTDOWN
1. Perform the Pressure Relief Procedure, page 9.
2. Turn spray tip 90º. This will prevent air from drying out any
spray material that may be inside the spray tip. Wrap spray
tip in a damp rag and then place entire spray gun in plastic
bag.
3. Pour 1/2 cup water slowly on the top of the paint to prevent
the paint from drying.
Place the entire spraying system out of the sun.
STARTUP
4. Remove the spray gun from the plastic bag or the water. Turn
the spray tip back to the spraying position.
5. If water was added during shut down, stir water into material
with the stir stick.
6. Follow Spraying instructions, page 11.
16
EN
SHORTTERM STORAGE

WAGNER Control Pro 150 Specifications

General

Type	Airless Paint Sprayer
Flow Rate	1.25 l/min
Hose Length	25 ft
Spray Tip Size	0.015 inch
Weight	19 lbs
Technology	Airless
Power Source	Electric
Nozzle Size	0.015 inch
Suitable For	Interior and Exterior Walls
Material Container Capacity	N/A (Direct Suction)