24
GB
MALFUNCTION CAUSE REMEDY
Atomisation too coarse
•
Material volume too large
•
Nozzle contaminated
•
Viscosity of coating material too high
•
Too little pressure build-up in
container
•
Air lter heavily soiled
•
Amount of air too low
•
Air hose damaged
•
Reduce volume
•
Clean
•
Dilute further
•
Tighten container
•
Change (see section 13.1)
•
Increase volume
•
Check and replace if necessary
Spray jet pulsates
•
Coating material in container running
out
•
Nozzle seal is missing or worn
•
Air lter heavily soiled
•
Feed tube loose
•
Feed tube / feed tube lter clogged
•
Rell
•
Insert an intact nozzle seal
•
Change (see section 13.1)
•
Insert
•
Clean or use another lter
The material runs down the
object being painted
•
Too much coating material applied
•
Distance too small
•
Incorrect spray attachment
•
Reduce volume
•
Increase distance
•
Use another spray attachment
Excessive paint mist (overspray)
•
Distance to the object too large
•
Too much coating material applied
•
Amount of air too high
•
Coating substance over-diluted
•
Incorrect spray attachment
•
Incorrect spraying technique
•
Reduce distance
•
Reduce volume
•
Reduce volume
•
Reduce degree of dilution
•
Use another spray attachment
•
For information about the correct spraying
technique, please see chapter 9
Paint in the ventilating hose
•
Diaphragm soiled
•
Diaphragm defective
•
Clean the diaphragm (see section 13.2)
•
Replace the diaphragm (see section 13.2)
15 ACCESSORIES AND SPARE PARTS
15.1 ACCESSORIES
POS.
ORDER NO.
DESIGNATION
1 2321 879 StandardSpray spray attachment (yellow) (with 1000 ml container)
Processes all standard paints.
2 2321 877 FineSpray spray attachment (brown) (with 1000 ml container)
Ideal for low-viscosity paints and glazes.
3 2321 880 WallSpray spray attachment (white) (with 1400 ml container)
Designed for processing dispersions.
4
2324 749
Container with cover (1400 ml)
The FC 3500 cannot be used with the heatable TempSpray spray attachment.
ACCESSORIES AND SPARE PARTS
To Next Page