18
EN
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Problem A: Little or no material ow
1. Nozzle clogged.
2. Suction tube clogged.
3. Air vent on suction tube blocked.
4. Material ow setting too low.
5. Suction tube loose.
6. No pressure build up in container.
7. Air valve tube not functioning.
8. Nozzle seal missing.
9. Air lter clogged.
10. Spray material too thick.
1. Clean.
2. Clean.
3. Clean (see page 16)
4. Increase material ow setting.
5. Remove and replace as tightly as possible.
6. Tighten container or container lid.
7. Make sure both ends of the tube are
connected and the valve seal is in place.
8. Replace nozzle.
9. Change
10. Thin*.
Problem B: Material leaking
1. Nozzle loose.
2. Nozzle worn.
3. Nozzle seal missing or worn.
4. Material build-up on air cap and nozzle.
5. No pressure build up in container.
1. Tighten.
2. Replace.
3. Replace nozzle.
4. Clean.
5. Tighten container or container lid.
Problem C: Spray pattern too thick,
runs and sags
1. Material ow setting too high.
2. Air power setting too low.
3. Applying too much material.
4. Nozzle clogged.
5. Air lter clogged.
6. Too little pressure build-up in container.
7. Spray material too thick.
1. Decrease material ow setting.
2. Increase air power setting.
3. Adjust material ow or increase
movement of spray gun.
4. Clean.
5. Change.
6. Tighten container or container lid.
7. Thin*.
Problem D: Spray jet pulsates
1. Material in container running out.
2. Air lter clogged.
3. Air valve tube disconnected.
4. Air vent on suction tube blocked.
5. No pressure build up in container.
1. Rell.
2. Change.
3. Reconnect both ends of the air tube.
4. Clean (see page 16)
5. Tighten container or container lid.
Problem E: Too much overspray
1. Gun too far from spray object.
2. Air power setting too high.
1. Reduce distance (6”-8” is ideal).
2. Decrease air power setting.
Problem F: Pattern is very light and
splotchy
1. Moving the spray gun too fast.
2. Material ow setting too low.
3. Air power setting too high.
1. Adjust material ow or decrease
movement of spray gun.
2. Increase material ow setting.
3. Decrease air power setting.
*Only thin the material as a last resort to improve spray performance.
Optimal spray performance should be acheived simply by adjusting the
various controls on the unit.
This unit contains no servicable electrical parts. Do not attempt to
service yourself. Store indoors with the cord wrapped around the
turbine handle.
Have you tried the recommendations above and are still having
problems? In the United States, to speak to a customer service
representative, call our Technical Service at 1-800-328-8251. See www.
wagnerspraytech.com in the “Contact Us” section for Technical Service
hours.
To Next Page
Loading...
Need help?
General
