6
EN
MATERIAL PREPARATION iSPRAY NOZZLE
1
2
3
TO PREPARE THE MATERIAL
Follow these steps for use with the iSpray nozzle
only. If using the gravity feed nozzle, skip to the
instructions on page 8-9.
1. Stir the spraying material thoroughly.
2. Unscrew the cup from the nozzle.
3. After the material has been properly thinned* (if necessary)
and strained, ll the container to desired level.
*THINNING THE MATERIAL
For certain spraying situations or desired nishes, thinning the
material may be desired. It is not necessary for most materials
when used with the iSpray nozzle. For use with the Gravity
Feed nozzle thinning may be needed to achieve a ner nish.
Make sure you adjust the X-Boost™ and Material ow settings
for your specic material needs.
If thinning is necessary, use the proper solvent as specied by
the material manufacturer. Never exceed the thinning advice
given by the coating manufacturer.
Do not thin with materials that have a ashpoint
below 100°F (38°C).
Material to be sprayed may need to be strained to remove any impurities in the paint which may enter and clog the
system. Impurities in the paint will give poor performance and a poor nish.
Only thin the material if absolutely necessary to improve spray performance. Optimal spray performance should be
achieved simply by adjusting the various controls on the unit.
To Next Page
Loading...
Need help?
General
