B23 Safety Instructions
15
SAFETY, CONTROL, AND INSTRUCTION DECALS
Safety, Control, and Instruction Decals are installed on the machine;
if any are missing, illegible, or damaged, a replacement should be ordered and installed before
putting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.
2.
3.
1.
4.
5.
Location: RH Fender
Part Number: 8600-48
1. Forward Speed Control
● Move lever forward to increase speed.
● Move lever back to stop.
2. Warning – read Operator’s Manual before
servicing or performing maintenance.
● Engage parking brake.
● Remove ignition key.
3. Warning – do not operate the machine without
a deck or other implement attached.
4. Throttle
● Move lever forward to increase engine
speed.
● Move lever back to idle.
5. Warning – roll-over hazard.
● Do not mow or drive the tractor within 5 feet
of an embankment with a drop o.
● Do not operate on slopes greater than 15
degrees.
● Do not mow within 5 feet of a body of water.
Location: Frame Crossmember Above Engine,
LH Side
Part Number: 6895-103
Change engine oil and oil lter every 300 hours.
To Next Page
Loading...
