Operating Instructions
43
1. Raise the body.
2. Pull up on each transaxle lockout arm and move
back to engage the step that holds the arm in
the UP (unlocked) position.
3. The mower will “freewheel” with the arms in the
LOCKOUT position. The levers must be in the
highest position to completely unlock the trans
axles.
Transaxle Lockout Arm
Transaxle Lockout Arm - Freewheel Position
4. After moving the mower, release the arms, plac
ing them down in the normal OPERATING posi
tion. The transaxle lockout arm ends should be
com pletely retracted against the chassis, other
wise operation of the transaxle may be erratic.
Transaxle Lockout Arm
Transaxle Lockout Arm - Normal Operating
Position
RECOMMENDATIONS FOR MOWING
DANGER
Do not mow around overhanging tree
branches or bushes at the same height as
the operator’s torso and head where inad-
vertent contact may cause injury.
Avoid Low Hanging Branches
IMPORTANT: Operate the engine at full throttle
when mowing, to allow the engine to produce full
horsepower and to increase eciency of the engine
cooling system.
● Keep the mower deck and discharge shield
clean.
● Mow with sharp blades. A dull blade tears the
grass (resulting in poor lawn appearance) and
uses extra power (slowing the mowing speed).
● It is preferable to cut grass when it is dry and
not too tall. Mow frequently and do not cut
grass too short. (For best appearance, cut o
1/3 or less of existing grass height.)
To Next Page
Loading...
