Walker H37i - Blade Drive; Tire Size; Tire Pressure; Drive Belts

Specications
4
MODEL H37i
TRANSMISSION (continued)
Parking Brake Internal Mechanical Cog Lock for each Transaxle
(Single Lever Control)
Neutral Transmission Release by Manual Dump Valve
Final Drive Direct Drive Axle from Transaxle
Transmission Fluid
Factory Service 20W50 MultiViscosity Motor Oil (Minimum SL Grade Oil)
Transmission Oil Capacity  oz (L) 77 (2.3)
Transmission Cooling Cooling Fan Mounted on Drive Pulley
Oil Filter HydroGear
®
P/N 52114 (Walker P/N 20266)
Ground Travel Speed
Forward MPH (km/h)
Reverse MPH (km/h)
010 (016) Innitely Variable
05 (08) Innitely Variable
BLADE DRIVE
PTO Shaft Quick Disconnect Sliding Spline Shaft with Two (2) HighSpeed
UJoints
Blade Drive Clutch and Brake Manual Belt Tightener Clutch and Band Brake
[Stops Blades within Five (5) Seconds of Disengagement]
TIRE SIZE
Deck Caster Wheel 13 x 4.506 (Pneumatic 6Ply)
Drive 22 x 10.5012 (4Ply LowProle)
Tailwheel 13 x 4.506 (Pneumatic 6Ply)
TIRE PRESSURE PSI (KPA)
Deck Caster Wheel 20 (137)
Drive 15 (103)
Tailwheel 20 (137)
DRIVE BELTS
Engine PTO Walker P/N 2230 (Set of 3)
Ground Drive Walker P/N 22481
SEAT Full Spring Suspension with Dampening and Adjustments for Back
Angle, Lumbar Support, and Operator Weight. Standard with Ad
justable/Retractable Armrests.
FRAME/BODY CONSTRUCTION
Frame All Welded Unitized Steel Chassis
Body 14 Gauge Steel
Deck 11 Gauge Steel