Walker R21 User Manual

1
Highlighted Information
Throughout this guide you will nd important infor-
mation labeled DANGER, WARNING, CAUTION,
IMPORTANT, and NOTE. Pay particular attention
to the information provided for your safety and the
safety and longevity of your equipment.
When you see the Safety Alert Symbol ( ),
read, understand, and follow the instructions. Fail-
ure to comply with safety instructions may result in
personal injury.
The seriousness or degree of importance of each
type of information is dened as follows:
DANGER
An IMMEDIATE hazard that WILL result in se-
vere personal injury or DEATH, if warning is
ignored and proper safety precautions are not
taken.
WARNING
A POTENTIAL hazard that COULD result in
severe personal injury or DEATH, if warning is
ignored and proper safety precautions are not
taken.
CAUTION
Possible hazards or unsafe practices that MAY
result in MODERATE personal injury or prop-
erty damage, or machine damage, if warning
is ignored and proper safety precautions are
not taken.
IMPORTANT: Identies mechanical information
demanding special attention, since it deals with
the possibility of damaging a part or parts of the
machine.
NOTE: Identies information worthy of special
attention.
Walker Manufacturing cannot predict every po-
tentially dangerous situation. Therefore, items
labeled as such in this manual do not cover all
conceivable situations. Most accidents associated
with the operation or maintenance of a Walker
Mower are caused by disregarding basic safety
precautions or specic warnings. Such accidents,
in most cases, can be prevented by being aware
of the dangers present. Any person using pro-
cedures, tools, or control techniques not recom-
mended by Walker Manufacturing must take full
responsibility for safety.
Walker Manufacturing recommends that any
service requiring special training or tools be per-
formed by an authorized Walker Mower dealer.
General Information
In this section...
Highlighted Information ......................................................................1
Glossary .............................................................................................2
Identifying Number Locations ............................................................. 3
Specications .....................................................................................4
Component Identication .................................................................... 7

Walker R21 Specifications

General

Drive System	Hydrostatic
Cutting Height	1.5 - 4.5 inches
Engine	Kohler CH740
Engine Type	Air-cooled
Cutting Width	52 inch
Wheel Size	20 inches (rear)