Walker T Series - Page 20

Safety Instructions
16
SAFETY, CONTROL, AND INSTRUCTION DECALS
Safety, Control, and Instruction Decals are installed on the machine;
if any are missing, illegible, or damaged, a replacement should be ordered and installed before
putting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.
Location: Deck Carrier Frame
Part Number: 8600-14
8600-14
1.
1. Warning – do not operate the machine with the
deck tilted up.
1. Warning – thrown object hazard.
● Keep bystanders away from the machine
when operating.
● Clear lawn of debris before operating.
● Keep any discharge deector in place and in
the lowest position.
2. Warning – rotating mower blades are a cutting/
dismemberment hazard to hands and feet.
● Keep all body parts away from rotating mow-
er blades.
● Do not step on end of deck.
Location: Deck Carrier Frame
Part Number: 8600-15
1.
1. Warning – lock deck tilt-up hinge before operat-
ing the machine.
Location: Deck Discharge Shield
(SD Decks Only)
Part Number: 5848-3
1. Warning – thrown object hazard.
● Always keep the discharge shield in the low-
est position when operating.
● Do not remove the discharge shield.
Location: Each End of Mower Deck
Part Number: 8600-28
8600-28
1.
2.
Location: Precleaner Tube
Part Number: 5082-5
Location: Gear Axle
Part Number: 5810-1
Location: Deck Gearbox Cover
Part Number: 8600-39
1. Warning - stop engine and remove ignition key
before adjusting deck cutting height.
1.
1.