Safety Instructions T27i
18
SAFETY, CONTROL, AND INSTRUCTION DECALS
Safety, Control, and Instruction Decals are installed on the machine;
if any are missing, illegible, or damaged, a replacement should be ordered and installed before
putting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.
2.
1.
3.
4.
Location: Front Body Adjacent to RH
Steering Lever
Part Number: 8600-34
1. Warning – read Operator’s Manual before oper-
ating the machine.
● Warning – wear eye and ear protection
when operating the machine.
2. Warning – roll-over hazard.
● Do not operate on slopes greater than 15
degrees.
3. Warning – thrown object hazard.
● Keep bystanders away from the machine
when operating.
4. Warning – entanglement hazard.
● Keep all guards in place while engine is
running.
8600-9
60 lb·ft (81 N·m)
Location: Gearbox Cover
(Gear-Driven Decks Only)
Part Number: 8600-9
Tighten blade nuts on gear-driven decks to
60 lb·ft (81 N·m).
8600 -12
Location: Front Body, LH Side Above Muer
Part Number: 8600-12
Warning – carbon monoxide (CO) poisoning
hazard.
● CO emitted by a running engine can be deadly.
● Do not operate indoors or in other enclosed
areas.
Location: Instrument Panel
Part Number: 8823-9
To Next Page
Loading...
