Walker T23 Operator's Manual

Maintenance Instructions T27i
Checking and Servicing
74
WARNING
DO NOT try to straighten a blade that is
bent. NEVER weld a broken or cracked
blade. ALWAYS replace with a new blade to
assure safety.
4. If the blade cutting edge is dull or nicked, it
should be sharpened. Remove blades for
sharpening by grasping the end of the blade
using a rag or a thick, padded glove, while
loosening and removing the nut, lock washer,
and at washer that mount the blade.
5. Grind cutting edge at the same bevel as the
original. Sharpen only the top of the cutting
edge to maintain sharpness.
NOTE: Blades can be sharpened with an
electric blade sharpener, conventional electric
grinder, or a hand le.
CAUTION
ALWAYS wear eye protection and gloves
when sharpening a blade.
Wing
Tip
Do Not Grind or
Sharpen on Underside
Intersection
Wear Area
Sharpen at
Original 30° Angle
30°
Mower Blade Prole for Sharpening
6. Check blade balance by positioning the blade
horizontally on a blade balancer or use a nail
or shaft through the center hole. If either end
of the blade rotates downward, grind (remove)
metal on that end until the blade will balance.
The blade is properly balanced when neither
end drops. Balance of a blade is generally
maintained by removing an equal amount of
material from each end of the blade when
sharpening.
Blade Balancer
Blade Balanced on Magnetic
Wall-Mounted Balancer
7. Mount the blade with wing tips pointing up into
the housing. For gear-driven decks reinstall
the blade, washer, lock washer, and nut.
Tighten the nut to 60 lb·ft (81 N·m). For
belt-driven decks reinstall the spacer (if ap-
plicable), blade, washer, and bolt. Tighten
the bolt to 70 lb·ft (95 N·m).
NOTE: When reinstalling blades on GHS
models, remember, the blades counter-rotate
and the LH and RH blades must not be
switched. Check for proper blade rotation
before installing blades on the deck. Refer to
Blade Rotation illustrations shown in Clog-
ging Checklist on page 47 for correct blade
rotation.
Drive Belts
Raise the body and inspect the condition of the
four (4) belts (3 belts on SD models) every 25
hours of operation—engine PTO drive, jackshaft
drive, hydrostatic ground drive, and GHS blower
drive. If the belts show signs of cracking or
deteriorating, the belts should be replaced.
Refer to Drive Belts on page 77.

Walker T23 Specifications

General

Brand	Walker
Model	T23
Category	Lawn Mower
Language	English