EasyManua.ls Logo

Walkera furious 320 - Ready for Flight; Binding the FURIOUS 320; Motor Unlock; Lock

Walkera furious 320
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FURIOUS 320
Quick Start Guide
7.0 Ready for flight
Q
j
Attention:
(1)
Place the aircraft on a flat surface, in an open space, with the back facing you.
(2)
Put all the function switches to the 0 position, put all trims/knobs to the Middle
position, move the throttle to the lowest position, then turn on the Remote Controller.
(3)
FURIOUS 320 has low voltage warning, no low voltage protection:
When the voltage below 14.2V, Left and right direction lights will flash slowly and the
buzzer will alarm, please land ASAP, to aviod crash.
7.1 Binding of the FURIOUS 320
0 Turn on the Remote Controller. (Make sure all the function switches, all trims/knobs and throttle stick
at the correct position)
0 Put the aircraft to the horizontal place and connect the aircraft power. (make sure the positive and
negtive connected correctly )
® The rear red LED flashes from fast to slow indicating that the code binding has finished.
(Note: When binding, do not move the FURIOUS 320.)
After bind successfully, please keep the aircraft arms level. The checking methods are as follow:
Adjust the AUX4 knob of the controller slowly to the best position where the user toggle the MIX swith,
the aircraft arms do not move.
Rear red LED
;=..
dam
i
.
111
Ensure the arms
keep level
O
O
7.2 Motor Unlock / Lock
Motor Unlock
After binding the DEVO-10 to the FURIOUS 320, Check that all trims are neutral, the throttle stick is ALL
the way Down with the display indicating 0% throttle. Check that ALL switches are in the UP position. Gently
push the throttle stick down and move the rudder (YAW) stick to the left side and
hold for more than 2 seconds.
(on mode 2 radios throttle and rudder is the same
stick). You will see the rear red LED light flash fast,
indicating that motors are unlocked. Be very careful
at this point, as pushing the thottle up will start the
motors. You can test by pushing the stick up a little,
the motors should start.
MODE 1 (Throttle stick on the right)
MODE 2 (Throttle stick on the left)
ELEV stick
Throttle / Rudder stick
ELEV/Rudder stick
Throttle stick
-7-

Related product manuals