EN - V2.0 19
5. Troubleshooting
Erratic Behaviour
Charger keeps waiting for current eventhough there’s no other car
• Poor contact on the CAN cables. Check that all the CAN cables are properly connected on
the chargers.
• Wrong configuration on the master.
• Wrong resistor value between CAN lines. Power o all the charger and measure the Ohm
resistor between CAN-H and CAN-L, it mut be around 60 Ohms.
• The current assignation may last up to 30 seconds.
• Make sure that there are no schedules programmed.
INSTALLATION GUIDE
To Next Page
Loading...
