Wallenstein BXMT3213 - Shredder Feed-Gate Levers; Discharge Chute; Hood Deflector

5.2 Shredder Feed-Gate Levers
The shredder has a spring-loaded feed gate. Press down on one
of the levers to open the feed gate and transfer material from
the hopper to the shredder rotor. The spring closes the feed gate
when the lever is released.
01084
Fig. 10 – Feed gate levers
5.3 Discharge Chute
The discharge chute can rotate 360°. A spring-loaded latch
handle locks it in position when released.
1. Lift the latch handle up until the chute lock pin disengages.
2. Rotate the chute to the required position.
3. Release the latch handle.
Make sure that the latch handle locks the discharge chute
into position at the nearest lock point.
01033
Fig. 11 – Rotate the discharge chute
5.4 Hood Deflector
The discharge chute has a deflector on the end to direct wood
chips. Use the hand knobs on each side to change the position.
1. Loosen the two hand knobs (turn them counterclockwise).
2. Rotate the deflector.
3. Tighten the hand knobs (turn them clockwise).
01034
Fig. 12 – Rotate the hood deflector
BXMT3213
Trailer Chipper / Shredder
Controls
21