6.7 Emergency Stop
In the event of an emergency:
1. Stop loading material into the machine.
2. Move the throttle control to the STOP position to turn off the
engine and close the fuel shut-off valve.
3. Remove the cause of the emergency before starting the
engine and resuming work.
6.8 Machine Setup
CAUTION!
Park the machine so prevailing winds blow
exhaust gases / fumes away from the operator.
W006
Use the tow vehicle to position the chipper / shredder at the
work area.
• Select a safe work area and machine location:
- Ground should be firm and level.
- Area must be clear of stones, branches, or hidden
obstacles that might cause a tripping, hooking, or
snagging hazard.
- There must be no overhead hazards such as
branches, cables, and electrical wires.
• Identify a safe wood-chip discharge location. Make sure
the wood-chip pile does not interfere with safe operation
of the machine.
Set up the machine:
1. Complete one (1) of the following:
• Disconnect the machine from the tow vehicle.
For instructions, see Connect to a Ball-Mount Hitch on
page 32.
• If extra stability is required, leave the machine attached
to the tow vehicle. Set the tow vehicle's parking break,
turn off the engine, and remove the key from the
ignition.
2. Lower the jack stand to support the machine. The machine
should be as level with the ground as possible.
3. Adjust the discharge chute to direct the wood chips away
from the operator's location and down wind.
For instructions, see Discharge Chute on page 21.
4. Adjust the hood deflector to direct the wood chips further
from or closer to the machine.
For instructions, see Hood Deflector on page 21.
5. Make sure that the upper housing is closed and secure.
6. Make sure that all of the guards are installed and secure.
01925
Fig. 16 – Machine setup
Operating Instructions
BXMT3213
Trailer Chipper / Shredder
28
To Next Page
Loading...
