5.16. Auto-Run
The Auto-Run function allows any output to automatically open at a set time every
day. There are 48 half hourly time activations settings available for each output.
Refer to section 7 to view the available time settings. When an output operates at the
set time, it is ON for the preset cycle run time as set in “Cell Water Settings” of the
WDC200 menu.
5.17. Technical Specifications
Table 4. Technical specifications
115-230V AC (Fuse 2 Amp), 50Hz Single phase, (UK, Europe,
Australasia)
Maximum Rating 60 Watts. (Refer to model WDCA200 for
North America).
To Next Page
Loading...
