Support Email/ Skype: service2@wansview.com 34
4.4.5.5 Mail Setting
4.4.5.6 SD/TF Setting
4.4.5.7 Reboot Device
Click to enter 【 Mail Setting 】 , when the user is using the mail alarm
function, Sender, Receiver, SMTP Server, SMTP Port(common port is
25,465 and 587), TLS etc. can be set.
Notice：
*User can select SMTP server according to your Mailbox server, if not
in the listed, please input manually.
*The Authentication must be ON, or the camera cannot log to the sender
email to send email.
* Please select SSL or TLS when the SMTP Port is 465 and 587.
Click to enter "SD/TF Card Setting". User can check the SD card capacity
and status.
Enable the “record overwrite”, the new recorded files will overwrite the old
files automatically.
The record time length can be set between 2-15 minutes
Enable the SD card recording, the camera will record constantly, here you
can set the video length, if you set 2 minutes, each video length will be 2
minutes
Reminders:
1. Please perform SD card formatting before SD card recording.
2. If SD card formatting is required during video recording, please stop SD
card recording first.
The duration of SD card formatting is about 20s.
Tap “reboot camera”, user can restart the
camera.
To Next Page
