18
07610-004-37-37-P
OPERATING INSTRUCTIONS
OPERATION
1. Flip ON/OFF switch to ON position.
2. Flip WASH/DELIME switch to DELIME position.
3. Add deliming solution per chemical supplier's instructions.
4. Close door.
5. Push START button.
6. Wait until cycle is complete and inspect inside of machine. If machine is not
delimed, run again.
UH30-FND and UL30: This equipment is not recommended for use with deionized
water or other aggressive uids. Use of deionized water or other aggressive uids
will result in corrosion and failure of materials and components. Use of deionized
water or other aggressive uids will void the manufacturer’s warranty.
DELIMING
UL30
If machine is equipped
with an SPS and lime is
becoming a frequent
problem, the cartridge
needs to be replaced.
To order a replacement
cartridge, call the
manufacturer.
To Next Page
Loading...
