WARN® INDUSTRIES PAGE 4 72171 Rev A0
IV. Installation
IV. A. Plow mount installation
1. Prior to installing the plow mount the vehicle must
be prepped. If not already done so, install a
WARN winch kit. Roller fairlead that comes with
the winch kit does not need to be installed. This
kit comes with a special fairlead to be used with
plow.
2. Begin by locating and removing the two rear
bumper mounting bolts. See Figure 1 and 2.
Figure 1 Location of bumper bolts to remove
Figure 2 Remove bumper bolts, both sides
Location of bolt to
remove
To Next Page
Loading...
