44
Service Information
Service Information
If there is a mains power failure the machines'
memory will remember the selected program for
about 8-10 minutes. The machine will restart
automatically when power is restored.
Program error is indicated by a number code in
the display panel.
For codes 01 and 02 a new start may be
attempted directly after the fault has been
rectified. In the case of other codes the mains
switch must be turned off and on again before the
machines can be restarted.
If codes 03-09 appear, contact authorised
personnel.
Fault Code Cause of fault
01 Water level low.
Open shut off valve. Try again.
02 Door lock defective.
Open and shut. Try again.
03 Short circuit in or to the
temperatue sensor.
04 Too high temperature, check
temperature sensor and cable.
05 Water in the machine at program
start.
06 Program defect.
07 Heating defective. (Steam or
electric heated machines only).
08 Machine not empty after drain
period.
1862
75
Fig.
75
To Next Page
Loading...
