Water Ace R25SP-01 User Manual (English)

Questions and Answers:

D
David ConwayAug 12, 2025
Why won't my Water Ace R25SP-01 start?
- J
  Janice WeaverAug 12, 2025
  Your Water Ace Water Pump might not be starting due to several reasons. It could be a blown fuse or breaker, in which case you should replace the fuse with the proper size or reset the breaker. Another cause might be low line voltage; if it's below the recommended minimum, check the wiring size from the main switch. If the wiring is okay, contact your power company. Other potential causes include a defective motor or float switch, requiring pump or float switch replacement, or an obstructed float, which you should remove.
A
Angela OrtizAug 19, 2025
What to do if my Water Ace Water Pump starts and stops too often?
- T
  Timothy OlsonAug 19, 2025
  If your Water Ace Water Pump is starting and stopping too frequently, it could be due to backflow of water from the piping. In this case, install or replace the check-valve. Another possible reason is a faulty float switch, which would need to be replaced.
A
Anne BaileyAug 27, 2025
What to do if my Water Ace R25SP-01 Water Pump operates but delivers little or no water?
- A
  Amanda HebertAug 27, 2025
  If your Water Ace Water Pump is running but not delivering enough water, one potential cause is low line voltage. Check the wiring size from the main switch; if the voltage is below the recommended minimum and the wiring is adequate, contact your power company. It could also be due to a worn or plugged impeller, which means you'll need to replace the pump. Another possibility is that the anti-airlock vent hole is plugged; try cleaning it out with a hat pin or pipe cleaner.
C
Catherine HillSep 4, 2025
How to fix a Water Ace R25SP-01 that won’t shut off?
- L
  Lee JacksonSep 4, 2025
  If your Water Ace Water Pump won't shut off, it could be caused by a defective float switch, which requires replacement. Another potential cause is a restricted discharge due to an obstacle in the piping; remove the pump and clean both the pump and the piping. Also, check for an obstructed float and remove any obstruction.