WaterLogic WL7 FIREWALL - General Information

3
ENG2152-22/05/19
WL7 FIREWALL
™
INTRODUCTION
1. GENERAL INFORMATION
• Carefully read and follow all instructions to ensure proper and efficient operation
of your water purification system. Contact Waterlogic or an authorised Waterlogic
distributor if you have any questions.
• Waterlogic water purification systems are made with selected water treatment
components to create a system specifically tailored for your application by trained
and qualified personnel.
• Waterlogic International Limited and WLI Trading Limited reserve the right, in order
to reflect continuous research and development, to amend or change specifications
without prior notice.
• Waterlogic® and the Waterlogic® logo, Firewall™ and the Firewall™ logo are trademarks
in countries where the Group operates. WLI Trading Ltd licensed to use BioCote®, and
BioCote® logo which are registered trademarks of BioCote® Ltd.
• Waterlogic technical manuals cover voltages of both 120V and 230V for all markets
where Waterlogic operates. Please ensure that you carefully read the information
in this manual and for any parts specific to any market, refer to your technical
agreement or specific part listing.
• Sanitise before use to eliminate any potential microbiological contaminants.
Ensure all local laws and codes including health and safety guidelines are met when
installing and using this Waterlogic purification system.
• Only qualified service technicians should attempt installation and service.
The product must be completely drained and sealed before storing or transported
to avoid stagnation and reduce microbiological contamination (potential bacterial growth).
• This unit is for indoor use only, never expose to direct sunlight, heat sources, to freezing
temperatures, ambient air temperature above 32°C (86°F) and keep the unit away from
from humidity levels above 65%.
• WARNING – Ensure there is adequate clearance around the unit to the allow the
condenser of the refrigeration system to dissipate heat. Warmer environments require
more clearance around the unit. Minimum clearance around all surfaces of the machine
is 100 mm. Keep all the ventilation openings, in the appliance enclosure or in the built-in
structure, clear of obstruction.
• Input or feed pressure must be regulated to 3 bar using a water pressure regulator
Waterlogic will not be responsible for injury or damage caused by excessive water
pressure.
• Water block devices and external leak detectors are strongly recommended.
• Products manufactured and marketed by Waterlogic and its affiliates are protected
by patents.
GENERAL INFORMATION