Watts BT-D03 RF User Manual

12
BT-D03-MOI-FR-W-EN-06-19
ENGLISH ENGLISH
EN
EN
RF pairing activation:
Pressing the key
starts
communication initialization:
Another press of key
will exit this mode.
Calibration of internal room sensor (remote):
Calibration must be done after a given order has been
operating for a day. Place the thermometer in the middle
of the room at about 1.5 m above the floor. Record the
temperature shown after 1 hour. When you enter calibration
mode for the first time, the indicator says “no”, which means
no calibration has been performed yet. Enter the reading on
your thermometer using the keys
and (step of 0.1°C).
The setting is validated with key
. YES appears to indicate that
calibration.
Important note: a large temperature deviation may indicate an
inappropriate installation of the thermostat. If the temperature differ-
ence is too big, this could mean your thermostat was not installed
properly e.g. in the right place.
NOTES: If user press simultaneously the keys
and , sensor
calibration is reset. No is displayed.
Default value: no for offset of 0.0°C
Range values: Yes: for offset included between -3.0°C and 3.0°C.
Degree unity for displaying:
➤ °C: Celsius
➤ °F: Fahrenheit
Default value: °C Values: °C / °F
Buzzer activation:
“Yes”: activation of function
“no”: no activation
Default value: no Values: Yes / no
“basic navigation” mode:
“Yes”: activation of function, restrict to comfort and off mode.
“no”: no activation
Default value: no Values: Yes / no
Room temperature display:
“Yes”: remote displays measured temperature
“no”: remote displays set point temperature
Default value: Yes Values: Yes / no
7. USER PARAMETER DESCRIPTION

Watts BT-D03 RF Specifications

General

Brand	Watts
Model	BT-D03 RF
Category	Thermostat
Language	English