14
IOM-S-Leak Defense 2211 2022-03-15 © 2022 Sentinel Hydrosolutions, LLC
THE WIRELESS CONTROL PANEL
Standby Scene allows water to flow
without alarming for the entire duration
of Standby. Ideally this is used to allow
contractors to work without causing
the system to alarm or when filling a
pool downstream of the system. If there
are POLDs installed, you can choose
whether or not they can alarm the
system during standby.
STEP 14:
Other features
DESIRED ACTION ON-SCREEN ACTIONS
Setting the Standby Scene Main Screen with Scene set to Standby (Water, Flow, and Scene
symbols are ORANGE).
Tap the Time icon in the bottom left.
Enter the time in minutes.
Tap the top right button to confirm the programmed time.
(Can be set from 1 minute to 48 hours based on customer’s preference.
Example: 3 hours = 180)
Alternative method to Turn Water Tapping the middle of the circular percentage bar brings up a menu with
On/ Off, Change Scene, Trip Rate, options to Turn Water On/Off, Change Scenes, and adjust the Trip
and Time to Alarm Rate and Time to Alarm as well as check the Status of the system.
ATTENTION:
Putting the leak defense system in standby
means water flowing into the structure is
NOT monitored. A leak will go undetected
in standby mode.
To Next Page
Loading...
Need help?
General
