DT-355
360°DualTechnology•LineVoltage
Occupancy Sensor
with Light Level feature
SPECIFICATIONS
Voltages ...................120/230/277/347VAC, 50/60Hz
Load Requirements
@120VAC, 50/60Hz ........... 0-800W Ballast/Tungsten
@230 or 277VAC, 50/60Hz .............0-1200W Ballast
@347VAC, 50/60Hz ...................0-1500W Ballast
Operating Temperature ..........32° to 131°F (0° to 55°C)
Terminal Torque Rating ... 4.428 inch pound-force. (0.5Nm)
Light Level One-Step Adjustment ............ 10FC–300FC
Time Delay Adjustment...................5 to 30 minutes
Walk-Through Mode .3 minutes if no activity after 30 sec.
Test Mode 5 sec. upon intial power-up or DIP switch reset
PIR Coverage (Typical) .........................1200 ft2
Sensitivity Adjustment..............................
............Automatic or Low (DIP switch setting)
Ultrasonic Coverage (Typical) ............... 800-1200 ft2
Sensitivity Adjustment...Minimum to Maximum (trimpot)
Frequency ...................................40kHz
Installation Instructions
U.S. Patents: 5,189,393
and Patent Pending
To Next Page
Need help?
General
