wattstopper CI-355 - User Manual

CI-355
v3
360° Passive Infrared • Line Voltage
Occupancy Sensor
with Light Level feature
SPECIFICATIONS
Voltages ............................................. 120//230/277/347VAC, 50/60Hz
Load Ratings
@120VAC .........................................0-800W Ballast/Tungsten/LED
@230VAC (Single Phase)...............................0-1200W Ballast/LED
@277VAC ...................................................... 0-1200W Ballast/LED
@347VAC ...................................................... 0-1500W Ballast/LED
Operating Temperature ................................ 32° to 131°F (0° to 55°C)
Light Level One-Step Adjustment ....................................10FC–300FC
Time Delay Adjustment ...............................30 seconds to 30 minutes
Walk-Through Mode ..............3 minutes if no activity after 30 sec.
Test Mode .......................................... 5 sec. upon DIP switch reset
PIR Coverage
Model CI-355 ............................................................... up to 1200ft
2
Model CI-355-1 .............................................................up to 500ft
2
Sensitivity Adjustment ............................ High or Low (DIP switch)
Santa Clara, CA 95050
Installation Instructions

Summary

Product Specifications

Voltages

Specifies operating voltages: 120//230/277/347VAC, 50/60Hz.

Load Ratings

Defines load ratings for various voltages: 0-800W to 0-1500W Ballast/Tungsten/LED.

Operating Temperature

Time Delay Adjustment

Adjustable time delay from 30 seconds to 30 minutes.

PIR Coverage Areas

Coverage areas: Model CI-355 up to 1200ft², Model CI-355-1 up to 500ft².

Sensitivity Adjustment

Coverage Patterns

CI-355 Coverage Pattern

360° coverage pattern for CI-355, up to 1200 sq ft. at 8ft height.

CI-355-1 Coverage Pattern

360° coverage pattern for CI-355-1, up to 500 sq ft. at 8ft height.

Placement Guidelines

Wiring Directions

Single Sensor, Single Load Wiring

Wiring diagram for a single sensor connected to a single load.

Multiple Sensors in Parallel Wiring

Mounting the Sensor

Mounting to a 4-Inch Square Junction Box

Mounting to an Octagonal Junction Box

Sensor Adjustment Procedures

Testing Occupancy Sensors

Light Level Feature

Setting the Light Level

DIP Switch Settings

Time Delay: Switches 1, 2, 3

Sensitivity: Switch 5

Troubleshooting Guide

Lights Dont Turn ON; Red LED Not Flashing

Lights Dont Turn OFF Automatically

wattstopper CI-355 Specifications

General

Product Type	Occupancy Sensor
Voltage	24VDC
Detection Range	360 degrees
Mounting	Ceiling
Wiring	3-wire
Color	White
Operating Temperature	32°F to 104°F (0°C to 40°C)
Type	Occupancy Sensor
Technology	Passive Infrared
Dimensions	4.5" diameter
Wire Size	18 AWG