SPECIAL REQUIREMENTS FOR INDOOR INSTALLATION
If you choose to install the spa indoors, please follow these instructions:
- The floor must be able to withstand the capacity of the spa. The floor must be a non-slip, level surface.
- Proper drainage is ESSENTIAL for indoor spa installation. It is recommended that a floor drain is installed.
- Running the spa indoors will cause humidity. It is the responsibility of the spa owner/user to determine the effects of airborne moisture on exposed
wood, paper, etc. in the proposed location. To minimize the effects of the humidity, provide plenty of ventilation to the area. It is recommended to
Seek advice from an architect to determine if more ventilation is needed.
- NEVER install the spa on carpet or any other material that can be damaged from moisture.
SPECIAL REQUITEMENTS FOR OUTDOOR INSTALLATION
If you choose to install the spa outdoors, please follow these instructions:
- It is important that you have a solid support foundation; ensure there are no sharp objects that could damage the spa and that the surface is level, so
the spa is stable.
- Always install the spa near a drain; there may be spillages during filling, emptying or when using the spa.
- Do not leave the spa’s surface exposed to direct sunlight for long periods of time.
ASSEMBLY
1. Unfold the spa from the packaging. Spread the spa cover making sure that it is the right side up.
2. Open the air outlet on the spa. Screw one end of the installation hose onto it.
3. Open the air valve on the spa. Connect the other end of the inflation hose into the valve.
To Next Page
Loading...
