4. Inflate the spa tub by pressing the “BUBBLE” button.
Once the spa is properly inflated, press the “BUBBLE” button again, this will shut off the bubbles.
DO NOT OVER INFLATE – If you want more inflation when the spa is filled with water, you must put on the jets for 2-3 minutes by pressing the “bubble”
button first and then operate according to steps 2-5 above.
5. Remove the inflation hose and screw the valve on tight.
6. Remove the inflation hose from the air outlet and screw the nut tight.
7. Screw the filter cartridge onto the water inlet on the spa wall by turning it clockwise.
To Next Page
Loading...
