10
4. USAGE
4.1. Control panel
4.2. Functions
WIFI Button
Temperature Increase
Button
Fahrenheit Degree
ON/OFF
LED Display
Centigrade Degree
Temperature Decrease
Button
Once powered-up, the LED displays the current water temperature automatically.
The temperature units selector changes the temperature units from Centigrade
degrees to Fahrenheit degrees.
Press the temperature adjustment buttons, then the screen will flash. When it is
flashing, you can set the desired temperature. The value will increase or decrease
1 degree at once. If you keep pressing the “+” or “-” for more than 2 seconds, the
value of the digital tube will increase or decrease rapidly at a frequency of 5/sec. The
temperature could be set between 30°C to 40°C (86°F to 104°F).
To lock or unlock the control panel, press the Lock button and hold 3 seconds. Lock
the control panel when you are away to prevent other people come to change your
settings.
Press the massage button to activate the bubble massage system, the green indicator
light turns on. It can be turned off by pressing it again.
Note:
- The massage system will stop automatically after 30 minutes of operation.
Re-activate the massage function by pressing the massage button again.
- When filter button is on, pressing bubble button will exchange filter mode into
massage mode: filter massage mode will be changed back to filter mode.
To Next Page
Loading...
