11
Press the filter button to activate the water filtration. The green indicator light will
turn on when the filtration system is activated.
Note:
- If massage function is on, the filtration can’t be activated.
Press the heating button to activate water heating and filtering system at the same
time. The green indicator light of filter and red indicator light of heating will turn on
the same time.
The pump does not stop heating until the current water temperature reaches the set
temperature; and the heating system will restart after the current water temperature
drops 2°C below the set temperature automatically. Maximum heating temperature:
40°C (104°F)
Important:
After 150 cumulative hours of filtration operations, an audible alarm will sound
and the LCD display will show the characters CHG, followed by FIL, to remind you
to change or clean the filter. You can hold the filtering button 5 second to turn off
the buzzing. The filtering system will turn off, you can press the button to active
the filtering system again.
Note:
- With heating system starting, the filtration system will start working together.
- After turning off the heating system, the filtration system will still work.
- If massage function is active, the filtration and heating functions can not be
activated.
1. Choose the function
2. Press the reservation button
3. Start reserving the time
4. Digital flashing display 0.5H and press ‘+’ and ‘-’ to adjust. If you keep pressing
the “+” or “-” for more than 2 seconds, the reservation time will increase or decrease
rapidly.
5. Press the reservation button again or no operation for five seconds, setup will be
completed.
Adjust the reservation function
In the reservation state, short press the reservation button to enter the reservation time setting
state.
Cancel the reservation function.
In the reservation state, press and hold the reservation button for 5 seconds to cancel the
reservation state and enter the standby state
4.3. Pool cover and security (Optional)
After each use, the control panel must be locked and the pool must be coated with its top cover and it
must be attached to the base protector with the safety buckles. Each safety buckles has a lock system
; closed buckle, the latch in up position locks the buckle, the latch in down position unlocks the buckle.
The top cover keeps the heat from the water and secures the pool.
To Next Page
Loading...
