Wavetronix Click 201 - Page 202

CHAPTER 23  CLICK 301 201
Startup
Allows you to configure active startup settings.
No Activity, the default, does not attempt to initiate a connection
under any circumstance.
Any Char attempts to connect when any character is received from the
serial port.
Active DTR accepts external connection requests only when the Mo-
dem Control In input is asserted.
Specific Char attempts to connect when it receives a specific start
character from the serial port. The default start character is a carriage
return. To change the character, see the Disconnect tab.
Manual Connect attempts to connect when directed by a command
string received from the serial port.
Autostart automatically connects to the remote IP address and remote
port specified when the firmware starts.
Modem Mode causes the unit to present a modem interface to the
attached serial device. It accepts AT-style modem commands and
handles the modem signals correctly.
Input Buer
Allows you to choose circumstances under which the input buer will
be flushed.
On Active clears the input buer when a connection is initiated from
the device to the network.
On Passive clears the input buer when a connection is initiated from
the network to the device.
At Disconn. clears the input buer when the network connection with
the device is disconnected.
Output Buer
Allows you to choose circumstances under which the output buer will
be flushed.
On Active clears the output buer when a connection is initiated from
the device to the network.
On Passive clears the output buer when a connection is initiated
from the network to the device.
At Disconn. clears the output buer when the network connection
with the device is disconnected.
Table 23.10 – Expert Driver Connect Tab
e Ethernet > Channel > Disconnect tab determines the conditions under which the unit
will cause a network connection to terminate (see Figure 23.13 and Table 23.11).