Wavetronix Click 201 - Chapter 4 - Installing Click Supervisor

In this chapter
 Installing Click Supervisor
 Microsoft .NET Framework
4
Once your Click devices are installed and wired, the next step is to install Click Supervi-
sor, a computer program that will help you work with your Click modules. Most Click
devices can be congured and monitored to some extent using the buttons and LEDs on
the module, but certain devices can be ne-tuned using Click Supervisor. ese computer-
programmable devices include the following:
 Click 101 – Multi-sensor to contact closure module
 Click 104 – 4-channel DIN rail contact closure module
 Click 110 – 4-channel contact closure Eurocard
 Click 112/114 – Detector rack cards
 Click 301 – Serial to Ethernet converter
 Click 304 – Intelligent RS-485 to RS-232 converter
 Click 306 – 1-port terminal server
 Click 400 – Autobaud 900 MHz spread spectrum radio
 Click 421 – Bluetooth® to serial converter
ere are also a number of Click 500 series devices that can be congured using Click Su-
pervisor; these are discussed in the Click 500 Series User Guide.
Installing Click Supervisor 4