CHAPTER 29 CLICK 421 253
e System tab is divided into three subtabs: General, Comm, and Autobaud.
e General subtab contains information about the device (see Figure 28.7 and Table 28.4).
Figure 28.7 – Expert Driver General Tab
Setting Description
Module
Shows the name of the Click device.
Driver
Names the driver you are currently working with.
Description
Shows a description of the device being configured. This is only for
your information and does not aect the operation of the device.
Location
Displays the location of the device being configured. This is only for
your information and does not aect the operation of the device.
Serial Number
Displays the serial number of your device.
Firmware Version
Shows the version of firmware your device currently has installed. If
Click Supervisor detects a discrepancy between this version and the
most current version it currently has access to, you will be prompted
to upgrade when you connect to the device.
Subnet ID
Shows the subnet ID number. This option is currently not available.
Device ID
Gives the ID number of the device being configured, which is used
to identify the device when you are connecting to it. By default, this
number is the last five digits of the serial number, which can be found
under the About tab or on the barcode sticker on the bottom of the
device. It is recommended that you do not change this number unless
another device on the network has the same ID number.
Table 28.4 – Expert Driver General Tab
e Comm subtab allows you to congure how the Click device communicates (see Figure
28.8 and Table 28.5).
To Next Page
Loading...
