254 CHAPTER 29 CLICK 421
Figure 28.8 – Expert Driver Comm Tab
Setting Description
Baud Rate
Allows you to change the baud rate at which the device connects to
the sensor.
Flow Control
Is used for configuring hardware handshaking. This option is currently
not available.
Parity
Allows you to set parity error checking.
Stop Bits
Allows you to set the number of stop bits.
Data Bits
Shows you the number of data bits being sent. This option cannot be
changed.
Active Port
Indicates on which port you are communicating with the sensor. This
option cannot be changed.
Latency
Indicates the latency between the sensor and the Click device. This
option cannot be changed.
Table 28.5 – Expert Driver Comm Tab
e Autobaud subtab allows you to congure how the device autobauds (see Figure 28.9
and Table 28.6).
To Next Page
Loading...
