CHAPTER 29 CLICK 421 255
Figure 28.9 – Expert Driver Autobaud Tab
Setting Description
Command
Allows you to set the command sent from the device during the
autobaud process. Don’t change these values unless instructed to by
Wavetronix Technical Services.
Response
Shows the response the device is expecting from the above com-
mand. Don’t change these values unless instructed to by Wavetronix
Technical Services.
SmartSensor ID
Shows the ID number of the sensor with which the Click device is
currently communicating. This only shows the number after you have
autobauded the Click device; when the Click device is not communi-
cating with a sensor, this option will display a 0.
Server/Client
Allows you to set whether the device is a server or client in a point to
multipoint setup (this option is not related to device autobauding).
This option is currently not available.
Table 28.6 – Expert Driver Autobaud Tab
e Bluetooth tab allows you to congure your device’s Bluetooth communications (see
Figure 28.10 and Table 28.7).
To Next Page
Loading...
