In this chapter
Serial Connection
Internet Connection
Virtual Connection
Multi-drop Network
Address Book
Viewing Connection Information
Uploading the Sensor’s Embedded Software
4
Once the sensors are installed, use the SSMA software to change settings, view data and
congure the sensors to the roadway.
Launch SSMA by either clicking on the icon that was placed on your desktop or clicking
the icon found in the Start menu. e SSMA main screen shown in Figure 4.1 will appear.
If you are using SSMA on a laptop computer, you can use the panel in the lower left of
the main screen to change the size of the user interface on your computer. Click any of the
three squares to increase or decrease the size of the user interface.
Communication 4
To Next Page
Loading...
