Wavetronix smartsensor advance - Chapter 10 Setup Output Communications; Configuring Data Push Parameters

In this chapter
 Configuring Data Push Parameters
9
e SmartSensor Advance is normally congured to operate in data push mode on port 2,
which means that the sensor initiates each output data transfer, instead of responding to
data requests from another device. e features located in the Setup Output Communica-
tion screen allow you to congure the data push parameters (see Figure 9.1).
Figure 9.1 – Setup Output Communications
Configuring Data Push Parameters
is section describes the four settings contained in the Output Communication Setup
screen.
Setup Output Communications 9