Weber mt CR 8 - Maintenance Operations Details; Checking Engine Oil Level; Changing Engine Oil

27
1
1
WARNING
If lubricating oils and fuel come into contact with skin,
they can cause skin irritations.
Wear protective gloves.
If skin contact has occurred, wash the a󰀨ected
areas thoroughly.
Park the machine on a horizontal subsurface.
Switch o󰀨 the engine and wait for several minutes until
the oil has collected in the crankcase.
Open the maintenance cover.
CAUTION! Danger of burn injuries at the hot engine and
its attachments.
Allow the combustion engine to cool down su󰀩ciently
before starting work.
Pull the oil dip stick (1) out of the crankcase.
Wipe o󰀨 the oil dip stick with a clean cloth.
Slide the oil dip stick back into the crankcase.
Pull the oil dip stick out of the crankcase.
The correct oil level is between the “min.” and the “max.”
marks.
When the oil level reaches the “min.” mark, ll in fresh oil
in accordance with the specication.
Close the maintenance cover.
CAUTION
Danger of burn injuries at the hot engine and its attachments.
Allow the combustion engine to cool down su󰀩ciently
before starting work.
Use extra caution during work on the engine when it is
at operating temperature.
Start the engine and allow the engine to warm up for a few
minutes.
Switch o󰀨 the engine.
Open the maintenance cover.
Unscrew the oil dip stick (1). It also serves as the seal
for the oil ller neck.
Open the side cover of the engine bracket.
Place a suitable collection vessel under the oil drain.
8.2.3. Check the engine
oil level
8.2.4. Change the engine oil