23
6. Transport
Lifting the machine
Storage for an extended period
7. Storage
Storage at the construction
site
The machine can be lifted for loading onto a vehicle.
CAUTION
Risk of material damage and injuries. The use of defective or
unsuitable lifting gear may cause the machine to fall down.
Use slings that possess the appropriate carrying capacity.
Lock the guide bar in place in the folded position.
Fit the crane hook into the lifting ring and lift the machine
up straight.
If the machine will not be used for a period longer than
one month, the following measures must be taken:
Clean the entire machine thoroughly.
Check the entire machine for leaks. Correct any detected
defects.
Empty fuel and ll the tank with clean fuel.
Check and, if necessary, correct the engine oil level.
Check and clean air and fuel lter. Replace if damaged.
Lightly oil all bare parts, levers and accelerator control cables.
Check the charging status of the battery, recharge if necessary.
Check the charging status of the battery on a regular basis,
but not less than every 3 months. Another option is to use
a permanent charger / battery maintainer.
If the machine is to be stored for longer than six months,
contact the Weber MT’s service organization to discuss
additional measures.
If stored at the construction site, e.g. over night, the machine
must be secured against theft and unauthorized use.
Parked machines presenting an obstacle must be secured in
accordance with statutory regulations, particularly in the area
of public trac surfaces.
To Next Page
Loading...
