Weber mt CR 8 - Compacting Process and Safety; Compacting Safety Precautions; Switching Off the Engine

22
ATTENTION
Danger of material damage or excessive wear if V-belt slips
through.
Operate the machine only in full-throttle mode, gas lever
position “ON”.
Start the engine.
Bring the gas lever into the full-throttle position “ON”.
Switch between forward and reverse travel by setting
the handle to the corresponding direction.
The forward and reverse travel of the machine is
innitely variable.
The speed of the machine is selected with the
corresponding deection of the handle
If the machine is equipped with the COMPATROL
compaction control system, the achieved compaction
of the soil can be read in the display.
The maximum possible compaction has been
reached when no additional LEDs come on after
the completion of another pass.
Switching o󰀨 the engine
Bring the gas lever into the idle speed position “STOP”.
Turn the ignition key to position “0”.
If necessary, pull out the ignition key and close
the vandalism ap.
CAUTION
Risk of injury if the machine is guided improperly.
Guide the machine safely with both hands on the handle.
CAUTION
There is a crushing hazard between the machine and
the wall during work in close proximity to walls.
Use extra caution when working close to obstacles
ATTENTION
Risk of damage to the machine. Never work on soils that
cannot be compacted further. The optional COMPATROL 2.0
compaction control system warns of hard soils.
If all LEDs of the compaction indicator light up together
with the warning light, stop operation immediately.
Compacting