21
Working with the machine
Starting the engine
Adjust the desired work height of the guide bar with
the set screw (position 2, gure 5).
Open the vandalism ap (position 1, gure 5)
Bring the gas lever into the full-throttle position “ON”.
Turn the ignition key to position “2” and hold it until
the engine turns over.
Release the ignition key as soon as the engine is running.
ATTENTION! Danger of material damage from running
electric starter.
The ignition key must spring back to position “1” automatically.
Otherwise, shut down the machine immediately.
Set the gas lever to the idle speed “STOP”.
The operational status indicator
signals that the machine
is ready for operation.
ATTENTION
Risk of engine damage if start procedures take too long.
One start procedure must not be longer than 30 seconds.
If the engine fails to turn over, the cause must be identied
and rectied.
WARNING
Danger of suocation from engine exhausts when starting
the engine in closed rooms or poorly ventilated work areas.
Start the engine only in well-ventilated environments.
See section “Safety” for operating the machine in trenches.
ATTENTION
Risk of engine damage. The use of starter spray may lead to
overheating in the combustion chamber.
Do not use any starter spray.
To Next Page
Loading...
