Weber mt DVH 655 E-2 - Hydraulic Fluid Replacement Procedure

24
Change hydraulic uid
.
Always drain the hydraulic uid when the roller is at a
standstill
Open the tank cap (1).
Remove the protective grating (1).
Remove the protective cap (1) from the drain connection
(2).
Screw the drain hose onto the drain connection (2).
As soon as the drain hose is screwed on, the drain
valve will open.
Danger of scalding due to hot hydraulic oil.
Allow the old oil to drain out completely.
Replace the protective cap (1).
Use the oil ller neck to ll in hydraulic oil in accordance
with the specication.
Remove the protective cap (1).
Check the hydraulic uid level in the view glass (1).
1
1
1
2