3
4
6
5
BURNER IGNITION & USAGE
METHODS OF BURNER
IGNITION
There are two ways to ignite
the burner. The first is by
using the ignition system
built into your barbecue. The
second is with a match.
Next are the steps for
igniting your barbecue using
the ignition system. On the
following page are steps for
igniting your barbecue with a
match.
Some batteries have a plastic
protective wrap around them.
This plastic must be removed
before you attempt to ignite
your barbecue. Do not
confuse this plastic with the
battery label.
BURNER IGNITION
A) Open the barbecue lid (1).
m DANGER
Failure to open the lid before igniting
the barbecue’s burner, or not waiting
five minutes to allow the gas to clear if
the barbecue does not light, may result
in an explosive flare-up which can cause
serious bodily injury or death.
B) Unfold the side tables(2) (Q
®
1200, Q
®
2000,
Q
®
2200).
C) Make sure the burner control knob is turned to the off
(
) position(3). Check by pushing burner control knob
in and turning it clockwise until it stops.
D) Confirm that the cartridge or cylinder is properly
installed.
E) Turn on the regulator valve using one of the
appropriate options based on your regulator type.
F) Push burner control knob in and turn it anti-clockwise
to start/high (
) position (4).
G1) Push the red igniter button several times, so it clicks
each time (5).
OR
G2) Push and hold in the electronic igniter button (6). You
will hear the igniter clicking.
H) Check that the burner is lit by looking through the
cooking grates. You should see a flame.
m WARNING: Do not lean over the open
barbecue while igniting.
m WARNING: If burner fails to ignite
within five seconds, stop, turn the
burner control knob to off and wait
five minutes to allow the gas to clear
before you try again or light with
amatch.
TO EXTINGUISH BURNER
Push burner control knob in and turn it clockwise to the off
(
) position.
m CAUTION: Do not fold in side tables
until barbecue is cold (Q
®
1200,
Q
®
2000, Q
®
2200).
To Next Page
Loading...
Need help?
General
