WWW.WEbER.cOm
®
33
TROUbLESHOOTING
PRObLEm cHEcK SOLUTION
Burners burn with a yellow or orange flame, in
conjunction with the smell of gas.
Inspect Spider / Insect screens for possible obstructions.
(Blockage of holes.)
Clean Spider/Insect screens. Refer to “ANNUAL
MAINTENANCE”.
Burners do not ignite. -or- Burners have a small
flickering flame in the HI position. -or- Barbecue
temperature only reaches 250° to 300° in the HI
position.
Some countries have regulators with an excess gas flow
safety device.
The excess flow safety device, which is part of the
barbecue to cylinder connection, may have activated.
To reset the excess flow safety device close the LP
tank valve and turn all burner control knobs to the OFF
position. Open the grill lid. Slowly turn the LP tank valve
until it is completely open. Wait at least one minute then
ignite your grill. Refer to “IGNITION.”
Burner does not light, or flame is low in HI position. Is LP fuel low or empty? Refill LP cylinder.
Is fuel hose bent or kinked? Straighten fuel hose.
Does the outside burner light with a match? If you can light the outside burner with a match, then
check the ignition system.
Burner does not ignite when you push the igniter
button.
Be sure that there is gas flow to the burners by
attempting to match light your burners. Refer to
“MANUAL IGNITION”.
If match lighting is successful, the problem lies in the
ignition system. Refer to “MAINTENANCE.”
Is there is a fresh battery installed? Verify that the battery is in good condition and installed
correctly. Refer to “BEFORE USING THE BARBECUE”.
Are the wires connected properly to the ignition module? Be sure that wires are correctly inserted into the terminals
on the ignition module. Refer to “MAINTENANCE.”
Is there plastic wrapping around the new battery? Remove plastic wrapping.
Is burner tube positioned too far away from the igniter
electrode?
Check that the burner tube is positioned correctly to the
igniter electrode. Refer to “MAINTENANCE.”
Experiencing flare-ups:
m CAUTION: Do not line the cookbox
with aluminum foil.
Are you preheating barbecue in the prescribed manner? All burners on HI for 10 to 15 minutes for preheating.
Are the cooking grates heavily coated with burned-on
grease?
Clean thoroughly. Refer to “CLEANING.”
Is the cookbox dirty and not allowing grease to flow into
catch pan?
Clean cookbox.
Burner flame pattern is erratic. Flame is low when
burner is on HIGH. Flames do not run the whole
length of the burner tube.
Are burners clean? Clean burners. Refer to “MAINTENANCE.”
Inside of lid appears to be “peeling.” (Resembles
paint peeling.)
The inside of the lid is Cast Aluminum, and is not painted.
It cannot “peel”. What you are seeing is baked on grease
that has turned to carbon and is flaking off.
THIS IS NOT A DEFECT.
Clean thoroughly. Refer to “CLEANING.”
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
PRObLEm cHEcK SOLUTION
Weber Q Grill Out
™
Handle Light does not light. Are the batteries old? Replace batteries.
Are the batteries installed correctly? Refer to assembly illustration.
Is the lid in the up position with the power button ON? Light will activate when lid is open.
Is the Weber Grill Out
™
Handle Light activated? Press the power button.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
.
To replace batteries, remove lightpod by removing screw (1). Push tab (2) and pull apart.
1
2
HANDLE LIGHT TROUbLESHOOTING - Q320
To Next Page
Loading...
