Weber 320 - Push-Button Ignition System Operations; Electronic Ignition System Operations; Electronic Ignition System Replacement

36
Q320
mAINTENANcE
PUSH-BUTTON IGNITION SYSTEM OPERATIONS
If the Push-Button Ignition System fails to ignite, be sure there is gas flow by attempting
to match light your burners. Refer to “MANUAL IGNITION”.
If match lighting is successful, the problem lies is the ignition system.
m WARNING: All gas controls and supply valves should be in
the OFF position.
• Checkthatbothignitionwiresareattachedproperlytoigniterelectrodes(1).
• Verifythattheignitionbuttonpushesin,clicksandreturnstotheoutposition.
If the ignition system still fails to light, contact the Customer Service
Representative in your area using the contact information on our web site. Log
onto www.weber.com
®
.
◆
ELECTRONIC IGNITION SYSTEM OPERATIONS
If the Electronic Ignition System fails to ignite, be sure there is gas flow by attempting
to match light your burners. Refer to “MANUAL IGNITION”.
If match lighting is successful, the problem lies is the electronic ignition system.
m WARNING: All gas controls and supply valves should be
in the OFF position.
• Checkthatboththeblack(1) and white (2) wires are attached properly to the
igniter electrodes on the ignition module.
• VerifythattheAAAbattery(alkalineonly)isingoodconditionandinstalled
correctly. Some batteries have a plastic protective wrap around them. This plastic
must be removed. Do not confuse this plastic with the battery label.
• MakesuretheElectronicIgnitionbuttonisworkingbylisteningandlookingfor
sparks at burner.
If the Electronic Ignition System still fails to light, contact the Customer
Service Representative in your area using the contact information on our web
site. Log onto www.weber.com
®
.
◆
ELECTRONIC IGNITION SYSTEM REPLACEMENT
If replacement of the ignition module is necessary it must be removed and disposed
of properly. Please see back page for further information on proper disposal.
◆
1
1
1
2