EasyManuals Logo

Weber GENESIS II E-330 User Manual

Weber GENESIS II E-330
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
13
A
B
C
D
E
Operation
m WARNING: Open lid during ignition.
m WARNING: Do not lean over open grill while
igniting or cooking.
m WARNING: Each burner must be ignited
individually by pushing the electronic ignition
button.
m WARNING: If ignition does not occur within
four seconds of attempting to light the first
burner, turn the burner control knob to
the o position. Wait five minutes to allow
accumulated gas to dissipate, and then repeat
the lighting procedure.
Igniting the Grill
Using the Electronic Ignition System to
Ignite the Grill
Each control knob operates an individual burner, and
each burner ignites independently. Ignite the burners
starting from left to right. All burners should be lit for
preheating, however, all burners do not have to be lit
while grilling.
1) Open the grill lid (A).
2) Check that all burner control knobs are in the o
position. Check by pushing in and turning knobs
clockwise (B).
Note: It is important that all burner control knobs are
in the o position before turning on the LP tank.
If they are not, the flow limiting device built into the
regulator will activate, limiting the flow of gas from
the LP tank.
3) Turn the LP tank on by slowly turning the tank valve
counterclockwise; wait 60 seconds (C).
Note: It is important that the LP tank is turned on
slowly. Ifit is opened too quickly, the flow limiting
device built into the regulator will activate, limiting the
flow of gas from the LP tank.
4) Begin with the burner furthest to the left. Push the
burner control knob in and turn it counterclockwise
to the start/high
position (D).
5) Push and hold the electronic ignition button (E).
Youwill hear it ticking.
6) Check that the burner is lit by looking through the
cooking grates and through the half-circle cutout in
the FLAVORIZER bar.
7) If the burner does not ignite, turn burner control
knob to the o
position and wait five minutes to
allow the gas to clear before attempting to light the
burner again.
8) If the burner ignites, repeat steps 4 through 6 to
light the remaining burners.
Should the burners fail to ignite using the electronic
ignition, refer to the TROUBLESHOOTING section.
Thereyou will find instructions on igniting the grill
with a match to help determine the exact problem.
To Extinguish Burners
1) Push each burner control knob in and then turn
clockwise all the way to the o position.
2) Turn gas supply o at the LP tank.
A
B
C
D
E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Weber GENESIS II E-330 and is the answer not in the manual?

Weber GENESIS II E-330 Specifications

General IconGeneral
Main Burners3
Side BurnerYes
Sear Station BurnerYes
Built-in ThermometerYes
Total Cooking Area669 sq in
BTU-per-hour Input Main Burners39, 000 BTU
Side Burner BTU-per-hour Input12, 000 BTU
Sear Station Burner BTU-per-hour Input9, 000 BTU
Cooking Area513 sq in
Warming Rack Area156 sq in
Grate MaterialPorcelain-enameled cast iron
Lid MaterialStainless steel
iGrill 3 compatibleYes
Side TablesYes
Tool HooksYes
Warranty10 years

Related product manuals