P
paulbellJul 30, 2025
What to do if Weber Grill burners do not light?
- MMatthew HoltJul 30, 2025
To reset the excess flow safety device on your Weber Grill, turn all burner control knobs and the cylinder valve to OFF. Disconnect the regulator from the cylinder. Turn burner control knobs to HI. Wait at least 1 minute. Turn burner control knobs to OFF. Reconnect the regulator to the cylinder. Turn the cylinder valve on slowly. Refer to “Lighting Instructions”. This issue may occur if the excess flow safety device, which is part of the barbecue to cylinder connection, has been activated.