7
Operation
m CAUTION: Inspect power cord before each use.
If cord is damaged, do not use. Contact the
Customer Service Representative in your area
using the contact information on our web site. Log
onto www.weber.com.
m CAUTION: Failure to properly store the rotisserie
power cord may result in damage to the power
cord when opening and closing the retractable
rotisserie panel.
m WARNING: Use heat-resistant grilling mitts or
gloves when operating grill.
Operating the Rotisserie
Preparing the Grill
Prepare grill for rotisserie cooking by removing
the warming rack and removing cooking grates.
RECOMMENDATION: Place a fresh foil pan (sold separately)
directly under food on top of the FLAVORIZER BARS (A).
NOTE: Set up the rotisserie with food before igniting the
infrared broiler.
1) To set up rotisserie motor, push the button on the
retractable rotisserie panel (B). Pull rotisserie panel
upwards. Push locking tab until it snaps into place.
Unwind power cord. Route the power cord through
the hole in the bottom of the rotisserie panel, then out
through the rear panel. Plug into power source.
2) To prepare the rotisserie for food, slide one spit fork
into the rotisserie shaft (C). Push the rotisserie shaft
through the center of the food. Slide the second spit
fork into the shaft and insert the tines of both spit forks
into the food. The food should be centered on the shaft.
Securely tighten both spit fork screws.
3) Insert the pointed end of the rotisserie shaft into the
motor. Lower the rotisserie spit into the grooves on the
cookbox (D).
4) Set infrared broiler on the low heat setting.
5) Switch on the motor and close the lid.
Cooking Tips
• Before cooking, make sure that the food is centered and
able to rotate. If food is too heavy or irregular in shape,
it may not rotate well and should not be cooked using
the rotisserie. In such cases, use the indirect method of
cooking on the grill.
• Truss meat or poultry with string, if necessary, to make the
shape as uniform as possible before putting it on the spit.
Use and Care
• Unplug the motor from outlet when not in use, or before
cleaning.
• Use a soft cloth to clean the rotisserie motor. Do not use
any chemicals or abrasive cleaners.
• Do not submerge motor, cord, or plug in water or other
liquid.
• Hand wash spit and forks using mild dish detergent and
then dry using soft cloth.
• When not in use, unplug the motor from outlet, remove
from the grill and store in a dry place out of the reach of
children.
• In absence of local codes the rotisserie motor must be
grounded electrically in accordance with the National
Electric Code, ANSI / NFPA 70, or Canadian Electrical Code,
CSA C22.1.
Rotisserie Motor Storage
1) Before retracting rotisserie back into the side table,
unplug the power cord and carefully place plug/power
cord into the storage area of the retractable rotisserie
assembly (E).
2) Using your index finger, disengage retractable
rotisserie panel. Push panel down until it snaps
securely in place.
Rotisserie Fork Storage
1) Remove forks from rotisserie shaft.
2) Store rotisserie forks by placing them on the hooks
located within the grill cabinet (F).
Rotisserie Shaft Storage
1) Store the rotisserie shaft on the hooks on the back of
the grill (G).
A
F
C
G
D
B
E
To Next Page
Loading...
Need help?
General