What to do if burner does not light, or flame is low in HIGH position on Weber Grill?
If burners do not light or the flame is low in the HIGH position on your Weber Grill, refill the LP cylinder if the LP fuel is low or empty. If the fuel hose is bent or kinked, straighten it. If you can light the Left burner with a match, then check the Crossover® ignition system.
What to do if the side burner on my Weber Summit does not light?
If the side burner on your Weber Grill doesn't light, it's possible the excess flow safety device has been activated. To reset it, turn all burner control knobs and the cylinder valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to the START/HI position and wait at least one minute. Then, turn the burner control knobs to the OFF position. Reconnect the regulator to the cylinder and slowly turn the cylinder valve on. For detailed instructions, refer to the “Lighting Instructions”.
What to do if the push button ignition on my Weber Grill does not work?
If the push button ignition on your Weber Grill is not working, try lighting the burner with a match. If the burner lights with a match, inspect the igniter, referring to the Sideburner Maintenance section for guidance.
How to fix erratic burner flame pattern on Weber Summit Grill?
If the burner flame pattern on your Weber Grill is erratic, the flame is low when the burner is on HIGH, or the flames do not run the whole length of the burner tube, clean the burners. See Section “Maintenance”.
How to fix low flame in HIGH position on Weber Grill?
If the flame is low in the HIGH position on your Weber Grill, check the fuel hose for bends or kinks and straighten it.
Why is the inside of my Weber Summit lid peeling?
The lid of your Weber Grill is stainless steel, not paint, so it cannot “peel”. What you are seeing is baked on grease that has turned to carbon and is flaking off. This is not a defect, clean thoroughly. See Section “Cleaning”.
How to fix yellow or orange flame on Weber Summit Grill?
If burners burn with a yellow or orange flame, in conjunction with the smell of gas on your Weber Grill, clean Spider / Insect Screens. See Section “Annual Maintenance”.
Why is the flame low on my Weber Grill when it's in the 'HI' position?
If the flame is low in the “HI” position on your Weber Grill, check the fuel hose. It might be bent or kinked. If it is, straighten the hose to allow proper fuel flow.
What to do if my Weber Grill is experiencing flare-ups?
To address flare-ups on your Weber Grill, ensure you are preheating with all burners on high for 10 to 15 minutes. Also, clean the cooking grates and Flavorizer® bars thoroughly if they are heavily coated with burned-on grease. Additionally, clean the bottom tray to ensure grease can flow into the catch pan. Remember, do not line the bottom tray with aluminum foil.
Essential safety warnings and instructions before using the gas grill.
Detailed list of hazards, risks, and precautions for grill operation.
Specific safety and handling instructions for liquid propane gas units.
Important information and safety precautions for handling liquid propane cylinders.
Steps to prepare the grill and cylinder for leak testing.
Step-by-step guide for connecting the propane cylinder to the grill.
Detailed procedure to check for gas leaks using soap and water solution.
Step-by-step guide for lighting the main burners using the ignition system.
Common problems and solutions for main burners and smoker function.
To Next Page
General
