32
PROBLEM CHECK CURE
Burner does not light.
Did you hold the burner control knob
down and hold down for 20 seconds until
after burner ignited?
Try to relight burner by holding burner
control knob down and continue holding
down until 20 seconds after burner has
ignited.
Did you wait to see the entire ceramic
surface become alight before counting 20
seconds?
When relighting burner by holding burner
control knob down, wait to see the entire
ceramic surface become alight before
counting 20 seconds?
Is the igniter sparking? Replace battery in igniter button module.
Reseat burner ring.
Burners do not light. -or- Burner hsa
asmall fl ickering fl ame
The excess fl ow safety device, which
is part of the barbecue to cylinder
connection, may have activated.
To reset the excess fl ow safety device
turn all burner control knobs and the
cylinder valve OFF. Disconnect the
regulator from the cylinder. Turn burner
control knobs to HIGH. Wait at least 1
minute. Turn burner control knobs OFF.
Reconnect the regulator to the cylinder.
Turn cylinder valve on slowly. Refer to
“Lighting Instructions”.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your
area using the contact information on our web site. Log onto www.weber.com
®
.
ROTISSERIE TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
